Printer initialization

Printer initialization resets the printer to the default settings. default settings. If you want to reset the printer to the If you want to reset the printer to the factory settings, proceed as follows, depending on the model. depending on the model:

Intermec E4

Turn off the printer.
Press and hold the "Feed Button" while turning on the you turn the printer back on.
Release the "Feed Button" when the printer's LED of the printer flashes green.
The printer now calibrates the labels (automatic measurement of the labels).
After a short waiting time the test labels are printed.
Press the "Feed Button" at least three seconds after the test labels are printed.
If you press Ok now, the initialization is started.

Intermec PC4 / PF8 (d/t/i) / OD5+

Turn off the printer.
Press and hold the "Feed Button" while turning the printer on again.
Release the "Feed Button" when the printer's LED of the printer flashes green
The printer now prints some labels with setup information. Wait until the LED turns green.
Press the "Feed Button" for at least for at least three seconds until the LED turns red.
Repeat step 1 up to and including 4.
Press the Feed button briefly to the labels are calibrated.

Intermec PF4i

Turn off the printer.
Open the side cover and use the lift to lift the printhead. the print head with the lift. Close the side cover again.
Press and hold the F5i button while you turn the printer back on.
Release the F5 (i) button when the printer first printer beeps for the first time.
Immediately press the F4, F2, F2 and F1 keys in quick succession. key in quick succession. The message 'Factory Default?' should appear.
Press ENTER within the next 10 seconds.
The printer is reinitialized. Wait until the status indicator lights up green and the 3rd led flashes blue.
Turn off the printer, open the side cover and use the side cover and use the lift to return the print head to its original back to the original position
Turn on the printer.
When the printer is ready, press the Shift and the Feed key at the same time to re-size the label. the label.

Intermec PM43c

Turn off the printer
Open the side cover and use the lift to lift the printhead. the print head with the lift. Close the side cover again.
Press and hold the Feed button while you turn the printer back on.
Release the Feed button when the status bar is status bar is almost full (printer with touch screen) or when the last two LEDs are lit (non-touchscreen printer).
Turn off the printer, open the side cover and use the side cover and use the lift to return the print head to its original back to the original position
Turn on the printer.
When the printer is ready, press the Shift and the Feed key at the same time to re-size the label. the label.

Sato LT408

Turn off the printer.
Turn DIP switch 2-7 to ON.
Press and hold the "Left", "Right" and "Enter" keys while turning the printer back on. turn on the printer.
Turn off the printer and set DIP switch DIP switch 2-7 back to off.